Pulmonary Artery Sealing Using the HARMONIC ACE+ Shears(HS) for VATS Lobectomy

The intraoperative techniques will not differ from standard resection techniques and blood vessel ligation will be performed according to standard operative procedures either using endostaplers or direct ligation of the pulmonary vessels.

After resection and removal of the resected specimen, the specimen will be examined ex-vivo, out of the operative field in a non-sterile field in the operative room. The lobar PA and its main segmental branches will be sharply dissected. Cannulation of a major segmental PA branch will be performed using our pressurization and monitoring device. The cannulation will be secured with a 2-0 silk suture. The vascular pressurization and recording device has been described in section E and is outlined in Figures 4 and 5. All pressure measurements will be recorded and graphed related to time from initial vascular pressurization to PA bursting pressure.

All distal segmental branches of the PA will be ligated to maintain the pressure throughout the catheterized segmental branch. An initial pressure of 25 mmHg will be obtained by inflating the vessel with normal saline. The lobar PA and the main segmental branches' diameters will be measured from vascular adventitia to adventitia. The lobar PA and the main segmental arteries will be sealed using the Harmonic Scalpel Ace+. The sealing will be performed with an intravascular pressure of 25 mmHg in order to simulate normal human PA pressures.

Following division of the PA, normal saline solution will be injected through the controlled pressure syringe pump in order to achieve an intralumenal vascular pressure until the bursting pressure is reached. Intralumenal pressure will be recorded at a frequency of 10 times per second. The bursting pressure will be recorded. Ex-vivo experimentation will take approximately 20 to 30 minutes. Burst pressure of the in-vivo endo-stapled (Endopath® ETS, 35mm, 2.5mm staples, white cartridge; Ethicon, Cincinnati, Ohio, USA) main lobar PA branches will be evaluated and recorded ex-vivo on the same specimens.

Endo-stapled vessels will be utilized as the size-matched control for energy sealed vessels in a 1:2 ratio. Allotment into the stapled or energy sealed group will be based on vascular size measurement prior to sealing. Attempts will be made to use the in-vivo staple line as the control vessel in all possible cases (size permitting) in order to increase the sample size of the energy sealed vessels.

Following vascular sealing, experimentation and recordings, the specimen will be sent for pathological evaluation of the resected lesion. All specimen manipulations will be strictly performed on the proximal main PA branches, away from the resected tumour. Care will be taken to not affect the pathological integrity of the resected lesion and its surrounding tissue and lymph nodes. Experimentation will be performed under the direct supervision of the attending thoracic surgeon in order to assure integrity of the specimen for pathological analysis.

Analysis will consist of between group comparisons of the efficacies and bursting pressure of both the energy sealed vessels (experimental group) and the endostapler-sealed vessels (control group). Vessels will be stratified by luminal diameter by millimeter. Primary outcome for analysis will be the intergroup comparisons of mean PA burst pressure by size of vessel. Intergroup differences will be compared with the student's t-test with bursting pressures entered as a continuous variable. Statistical testing for normality of data will be performed and when data is non-normal, non-parametric methods (ex: Wilcoxon Rank Sum Test…) will be used. Multivariable linear regression models will be employed in order to compare burst pressures between groups controlling for potential confounders (disease state, size of vessel sealed, age of patient, sex, pulmonary lobe, laterality, immunosupression, diabetes, vascular disease…).