Comparing Wound Complication Following TMA With Aid of Electrospun Fiber Matrix

Intervention or Exposure

• Transmetatarsal amputation with application of synthetic electrospun fiber matrix
• After surgery, patient will be off-loaded to the surgical site with an off-loading device based on the investigator's decision, e.g., a boot for forefoot and a heel protector for hindfoot. Patients should be instructed on how to care for the surgical site, utilize an off-loading device, and keep the surgical site moist and clean.

Comparison intervention or Exposure

• Transmetatarsal amputation without application of synthetic electrospun fiber matrix
• After surgery, patient will be off-loaded to the surgical site with an off-loading device based on the investigator's decision, e.g., a boot for forefoot and a heel protector for hindfoot. Patients will be instructed on how to care for the surgical site, utilize an off-loading device, and keep the surgical site moist and clean.

Outcomes

• Primary: Infection rate at 1 week postoperative follow-up visit
• Secondary: Wound dehiscence rate and wound healing status at 12 weeks post operatively. Infection rate at 2, 4, and 12 weeks post operatively.
• Patients will have follow-up visits at week 1, 2, 4, and 12. Assessment and imaging of the wound will occur at each visit. Assessment of adverse events, infection, and dehiscence will occur during each visit. Assessment of wound(s) through gross observation and analysis, wound progression, and tissue healing. Gross observation will be utilized to determine the necessity of standard dressing change. Carefully assess the wound(s) for signs of infection, dehiscence, and description of exudate present. Debridement and dressing changes may occur at each weekly visit or as needed. Debride the wound(s) as needed while not disrupting healing tissue. Photographic image will be obtain to document wound appearance. The clinician will inspect the wound bed for signs of infection and healing. Frequency of secondary dressing changes will be dependent upon the volume of exudate produced, type of dressing used and the clinician's decision upon inspection of the wound(s).
• Measurement and imaging of wound(s). If debridement is completed during this visit, then the assessment must be completed after debridement.

Timing of study

• Preop visit for eligibility and randomization
• Surgical visit: TMA with or without application of synthetic electrospun fiber matrix
• 1, 2, 4, and 12 week post-op visits.

Setting of study

• Inpatient at Scripps Mercy Hospital
• Outpatient follow-up Scripps Mercy Podiatry Specialty Clinic or Dr. Brookshier's private clinic North Park Podiatry

Study exit: patient's participation in the study will end after any of the following

• Completion of 12 week follow-up period
• Pathology results from TMA surgery revealing active infection within remaining surgical margins
• Patient withdrawal
• The Investigator may withdraw the patient if he/she determines it is in the patient's best interest
• Patient lost to follow-up
• Amputation of the study limb
• Closure of study
• Patient death

Variables that can be collected: HbA1c, patients that require revascularization prior to TMA due to poor vascular status, age, gender, smoking status

Application of synthetic electrospun fiber matrix (SEFM)

1. Wound Bed Preparation post TMA. Following amputation, prepare the wound bed using standard methods to ensure it is free of devitalized tissue. An initial excision or debridement of the wound is necessary to ensure the wound edges contain viable tissue. Cleanse the wound thoroughly with sterile saline prior to application of SEFM.
2. Preparation of SEFM. Select the appropriate size sheet of SEFM based on the size of the post-amputation defect. Heavily fenestrate with a scalpel or mesh prior to application. SEFM must be fenestrated prior to use in any wound prone to exudate in order to permit effective exudate management. SEFM is packaged in a nested pouch configuration. Peel open the outer foil pouch starting from the chevron sealed edge. The inner pouch is sterile and may be placed on the sterile field. Rinse surgical gloves, if necessary, to remove any glove powder prior to touching the product. SEFM can be cut to the desired shape in a wet or dry state. In order to increase pliability of the product, hydrate in warm, sterile, hypertonic solution (i.e., saline, water, etc.) for a minimum of 1 minute. The matrix should be cut down to fit the size of the wound and applied in full contact with the wound bed.
3. Application of SEFM. Place the SEFM within the surgical defect within the open space. Discard any unused pieces of study product. Management of wound exudate will determine the required dressing. The dressing will be securely in place and dressing determined by provider preference.

Adverse events will be documented. The following adverse events whether or not they are related to a study product/procedure:

• Infection of wound and/or area surrounding wound
• Complete or partial amputation of lower extremity
• Allergic reaction to a study product
• Excessive redness, pain, swelling or blistering of wound