In the Treatment of Implants With Different Methods; Early Bone Loss and Patient Satisfaction

Filling the Case Report Form for each registered patient and signed by the responsible investigator or an authorized representative of the study staff. This also applies to records for patients who could not complete the study (even if a case report form was prepared, even during screening prior to randomization). If a patient withdraws from the study, the reason for this is recorded in the Case report form. If a patient withdraws from the study because of a limiting adverse event, all necessary efforts will be made to clearly document the result.

All forms must be filled with a typewriter or an indelible ink pen and must be readable. Errors can be crossed out, but errors cannot be deleted; the correction is entered and the change is initialed and dated by the investigator or his authorized representative. The researcher should ensure the accuracy, completeness and legibility of the data reported to the sponsor in the case report forms and all required reports and that it was processed on time.

The researcher is responsible for the accuracy of the data transferred on the forms and will sign these forms in the sense of showing their compatibility with the recorded data.

As a result of the power analysis made with G * Power3.1 (Franz Faul, UniversitätKiel, Germany) software program, it has been determined that the sampling number consisting of 20 people with 0.8 effect size and α = 0.05 significance level generates more than 80% power. it was deemed appropriate to include a total of 24 people in the study. Karim M. Ahmed A, Salah Abd Elfatah B, Mohamed Abd El-Mageed Katamish's ''Crestal bone loss of standard implant versus platform switch implant design using minimal invasive technique'' article is used as a reference for marginal bone loss data calculation.

Patients with sufficient amount of bone were included in the study after bone sounding and x rays were evaluated after local anesthesia before surgery. By an unbiased researcher, the patients were recruited to the groups using the envelope method; control group (with flap raised) or test group (without flap raised) were assigned.

A total of 24 patients complying with these criteria were included in the study and a total of 37 implants were applied to the patients.

Implant applications of the patients in the control group were performed by lifting the flap. The implants of the patients included in the test group were applied without lifting the flap.

For each implant in the study marginal bone loss were evaluated; Digital bite-wing x-rays taken with a standard technique were used.Bite-wing x-rays taken were standardized with bite blocks on the film holder prepared individually for each patient. From each implant site; two x-rays were taken first immediately after implant surgery and the second three months later, just before the uncovering session of the implants. Digital bite-wing x-rays were transferred to RadiAnt Dicom Viewer program and measurements were made on them. Implant diameter values which is known in the images are accepted as reference.The diameter in the image was measured and a coefficient was obtained by dividing the real diameter to measurement on image. In the images, the distance between the most coronal point of the implant neck and the point where the implant bone contact first occurred was measured. This distance was divided by the coefficient obtained and its actual values are obtained in mm.The difference between these distances at two time points were recorded in patient forms as marginal bone loss. In statistical analysis, comparisons between groups were made.

All the individuals included in the study came to the control appointments on the 3rd and 7th days after implant surgery, and the sutures were also taken on the 7th day. All patients were asked to fill the Turkish translation of Oral Health Impact Profile (OHIP-14) forms three times: preoperatively, postoperative day 3, and postoperative day 7. Visual Analog Scale (VAS) forms were asked to be marked by the patients on the 3rd and 7th days after the operation. VAS forms were prepared as a horizontal line with one side being the lowest score and the other side with highest score. VAS forms were prepared to be in 0-100 mm and the point marked by the patient was measured in cm. In VAS forms, patients were asked to mark according to their post-operative pain status.

Statistical analysis of the data in this study was done with Statistical Package for the Social Sciences (SPSS) 20 (International Business Machines Corporation Somers, New York, USA) package program.In the evaluation of the data, besides descriptive statistical methods (mean, standard deviation), T test was used for comparisons between groups. ANOVA test was used for multiple group comparisons. Statistical significance level was determined as p <0.05 .